SkitterTV Frequently Asked Questions

SkitterTV Remote Quick Guide

STEP 1: Turn on the TV set.

STEP 2: Press the TV button and the OK/SEL button simultaneously for 3 seconds. The TV LED light will turn on for 30 seconds indicating the unit is ready to be programmed.

STEP 3: Point the remote control toward the TV and enter the 3-digit code number assigned to your brand. You can see a list of the most popular TV brands and codes below.  PLEASE NOTE: If the 3-digit code number you just entered is correct, the TV will turn OFF. If it did not turn OFF, continue entering code numbers listed for that brand until the TV turns OFF.

LG: 363, 113, 116, 102, 106, 112, 119, 127, 143, 284
Panasonic: 080, 034, 056, 092, 164, 208
Samsung: 258, 050 ,089 ,105, 127, 143, 160, 228, 229, 363
Sony: 001, 139, 147, 126, 185, 085, 213, 277
Toshiba: 138, 015, 030, 007, 040, 062, 101, 325
Vizio: 386, 387

STEP 4: After you have entered the correct code number and TV has turned OFF, press the POWER button to turn the TV back On. Now it’s time to test the VOLUME and MUTE buttons for the TV to make sure they work. If any of the functions do not work as they should, repeat from STEP 3 using the next 3-digit code number listed for that brand.

STEP 5: Once you have found the correct 3-digit code, save it by pressing the TV button one more time. The TV LED light will blink twice to confirm that the code was successfully stored.

If the above 5 steps do not work you can use the auto-search method:

STEP 1: Turn on the TV set.

STEP 2: Press the TV button and the OK/SEL button simultaneously for 3 seconds. The TV LED light will turn on for 30 seconds indicating the unit is ready to be programmed.

STEP 3: Point the remote toward the TV and press the (CH ↑) or (CH ↓) button one step at a time or keep in pressed. The remote will emit a series of ON/OFF commands. Release the (CH ↑) or (CH ↓) button as soon as the TV turns OFF.

STEP 4: After you have “found” the correct code number and TV has turned OFF, press the POWER button to turn the TV back On. Now it’s time to test the VOLUME and MUTE buttons for the TV to make sure they work. If any of the functions do not work as they should, repeat from STEP 3 going in the opposite CH direction.

This is an issue we see frequently. Please note this is normally not an issue with your SkitterTV but rather an issue with your TV not being on the correct input to be viewing your SkitterTV.

First check to see that the set-top box is turned on and not in “standby” mode. If the tv and set-top box is turned on then this is most likely an input issue.

To correct this issue, you must find the correct input that your set-top box is connected to your TV. This varies widely by TV brand but generally you can cycle through your inputs by pressing the “Video Source” button on the remote provided by Huxley Communications. If this does not work, please use the remote that came with the TV. You will be looking for a button marked “Input” or “Source” or “Video Source”.Occasionally the source list may be found under a “menu” button. For further assistance you should refer to your TV manual or contact the manufacturer directly.

Once the TV is on the correct input, you will again see the correct programming and no longer see the “weak or no signal” message.